TM 1-1520-238-23
7-110
7.32.
DIRECTIONAL SERVOCYLINDER REMOVAL – continued
m. Remove servocylinder (3) from pivot bracket
(38).
(1) Remove and discard cotter pin (39).
(2) Hold bolt (40). Remove nut (41).
(3) Remove bolt (40).
(4) Remove servocylinder (3).
NOTE
Perform step n off helicopter if replacing
servocylinder.
n. Measure and record distance A between cen-
ter of rod end bore (42) and top of servocy-
linder piston rod (43). Keep recorded
measurement for installation of new servocy-
linder.
7.32.4. Cleaning
a. Clean removed and attaching parts (para
1.47).
7.32.5. Inspection
a. Check hoses for fraying, tears, or cuts (para
7.1).
b. Check adapters for stripped or damaged
threads (para 7.1).
c. Check control arm, bellcrank, and pivot brack-
et for cracks, nicks, or dents (para 7.1).
d. Check removed and attaching parts for corro-
sion (para 1.49).
GO TO NEXT PAGE
M04-779-7
3
40
41
39
38
A
M04-779-10
43
42
