TM 1-1520-238-23
Change 3 9-141/(9-142 blank)
9.40.
HELICOPTER BATTERY REMOVAL/INSTALLATION – continued
9.40.6. Installation
WARNING
When battery is connected and APU
start switch is set to START, APU will
start and run with battery switch in off
position. If APU were to start, death or
serious injury could result. If injury
occurs, seek medical aid.
CAUTION
To prevent damage to battery floor
threaded inserts, do not exceed
25 INCH-POUNDS of torque.
a. Install battery (3). Torque four bolts (6) to 25
INCH-POUNDS.
(1) Install four bolts (6) and washers (7).
(2) Torque four bolts (6) to 25 INCH-POUNDS.
Use torque wrench.
NOTE
Ensure cables do not chafe battery baffle
assembly on floor.
b. Attach connectors P87 (2) and P81 (1) to bat-
tery (3).
(1) Attach connector (2) to battery receptacle
(BT1)J3 (5).
(2) Attach connector (1) to battery receptacle
(BT1)J2 (4).
c. Inspect (QA).
d. Perform battery maintenance operational
check (TM 1-1520-238-T).
e. Secure access door R295 (para 2.2).
END OF TASK
1
4
6
7
5
2
M04-1139-4
3
