TM 1-1520-238-23
Change 1 9-343
9.94.
TAIL OR WING NAVIGATION LIGHT INSTALLATION – continued
WARNING
Do not place heater near flammable
material or allow heater to contact
skin: severe burns can result. Wear
protective equipment. If injury occurs,
seek medical aid.
NOTE
The following steps are for installation
of the tail navigation light.
If heat shrink is installed on tail naviga-
tion light wire terminals, go to step j.
f. On each wire (13), install 1.50 INCH length of
heat shrink tubing (14) on terminal lug (15).
Use insulation sleeving (item 105, App F)
(TM 55-1500-323-24) and heater.
g. Install second 1.50 INCH length of tubing (14)
on tubing installed in step f. Use insulating
sleeving (item 98, App F) (TM 55-1500-323-24)
and heater.
h. Install 1.00 INCH length of heat shrink tubing
(16) around lug (15) and over tubing installed
in step g. Use insulating sleeving (item 98,
App F) (TM 55-1500-323-24) and heater.
NOTE
If expandable sleeving is installed on
navigational light wires, go to step q.
i. Remove access panel R578 (para 2.2).
GO TO NEXT PAGE
M04-1246-3A
15
16
14
15
13
14
