TM 1-1520-238-23
Change 3 9-585
9.154.
DATA LINK TERMINATION UNIT (DLTU) T37, T38, T39, OR T40 REPLACEMENT – continued
(9) Position insulating sleeve (17) over both insu-
lating sleeves (21).
NOTE
Ensure wire braid areas are not covered.
(10) Apply heat until insulating sleeve (17) fully
shrinks. Use heater.
f. Install shield splice (19) and solder sleeves
(18).
(1) Position shield splice (19) over exposed wire
braids (5) and (11).
NOTE
Ensure solder ring is centered over wire
braid and shield splice.
(2) Position two solder sleeves (18) over shield
splice (19).
(3) Apply heat to solder sleeves (18) until full ring
flow has occurred. Use heater.
g. Install sleeve/marker (16).
(1) Center sleeve/marker (16) over finished
splice on leads (3) and (2).
(2) Apply heat until sleeve/marker (16) fully
shrinks over splice. Use heater.
h. Repeat steps e. through g. for remaining four
leads.
i. Install clamps as required.
j. Inspect (QA).
k. If necessary, install ENCU overboard exhaust
duct (para 13.13).
l. If necessary, install aft catwalk panel (para
2.84).
GO TO NEXT PAGE
M04-5145-18
21
21
17
M04-5145-19
5
17
18
18
19
11
M04-5145-20
3
16
2
