TM 1-1520-238-23
11-22
Change 6
11.3.
FLIGHT CONTROL SYSTEM PUSH-PULL ROD NON-ADJUSTABLE ROD END BEARING
REPLACEMENT – continued
11.3.4. Cleaning
a. Clean removed and attaching parts (para
1.47).
11.3.5. Inspection
a. Check clevis bolt, nuts, and washers for dam-
age and wear (para 11.5).
b. Check clevis bolt, nuts, and washers for cor-
rosion (para 1.49).
11.3.6. Installation
a. Install new rod end bearing (1) on rod (2).
(1) Install nut (7) on rod end bearing (1) as far as
it will go.
(2) Install keywasher (8) on rod end bearing (1)
as far as it will go.
(3) Install rod end bearing (1) on rod (2).
(4) Aline bolt hole (9) in fixed nut (6) with hole
(10) in rod end bearing (1).
(5) Hold rod end bearing (1) in position and slide
keywasher (8) down to engage key in slot in
rod (2).
GO TO NEXT PAGE
M04-4259-3
2
1
7
8
M04-4259-4
1
10
6
2
9
