TM 1-1520-238-23
11-453
11.102. LATERAL F.S. 159.13 BELLCRANK REMOVAL/INSTALLATION – continued
c. Install rod (13) on bellcrank (14). Torque nut
(16) 30 to 40 INCH-POUNDS.
(1) Aline rod (13) with bellcrank (14).
(2) Install bolt (17) through washer (18), bushing
(19), bellcrank (14), and rod (13).
(3) Check fit of self-retaining bolt (17) (para
11.1).
(4) Install nut (16). Torque nut (16) to 30 INCH-
POUNDS. Use torque wrench.
(5) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(6) Install new cotter pin (15).
d. Inspect (QA).
e. Install cover (1) on bulkhead (2).
(1) Aline holes in cover (1) with holes in bulkhead
(2).
(2) Install 18 screws (11) and washers (12).
(3) Secure insulation (10) on bulkhead (2) by fas-
tening pile tape (32) on hook tape (33).
(4) Install two clamps (5) and (7) on wire har-
nesses (8) and (9).
(5) Install screw (3) through washer (4), clamp
(5), spacer (6), clamp (7), and bulkhead (2).
f. Inspect (QA).
g. Install Air duct No. 11 (para 13.27).
h. Install pilot seat (para 2.161).
i. Perform lateral flight control rigging mainte-
nance operational check (TM 1-1520-238-T).
END OF TASK
17
18
19
16
13
14
15
M04-4360-9
1
M04-4360-10
12
11
2
32
10
33
M04-4360-11
6
7
8
9
3
4
5
2
