TM 1-1520-238-23
11-563
11.127. LONGITUDINAL F.S. 164.38 PUSH-PULL ROD REMOVAL/INSTALLATION – continued
b. Install rod (13) on bellcrank (14). Torque nut
(16) 30 to 40 INCH-POUNDS.
(1) Aline rod (13) with bellcrank (14).
(2) Install bolt (19) through two washers (20),
weight (21), bellcrank (14), and rod (13).
(3) Install bushing (18) and weight (17) on bolt
(19).
NOTE
The maximum thickness for washer
stack-up under the bolt head is 0.124
INCH.
(4) Check fit of self-retaining bolt (19) (para
11.1).
(5) Install nut (16). Torque nut (16) to 30 INCH-
POUNDS. Use torque wrench.
(6) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(7) Install new cotter pin (15).
c. Inspect (QA).
d. Remove -9 rig pin (9) and -5 rig pin (11) from
housing (8).
e. Remove cover (12) from stick (6).
GO TO NEXT PAGE
17
16
15
18
19
M04-3592-7
14
20
21
13
9
12
11
8
10
M04-3592-9
6
