TM 1-1520-238-23
11-892
11.205.
PILOT COLLECTIVE CONTROL VARIABLE RESISTOR REMOVAL/INSTALLATION – continued
d. Remove variable resistor (3) from arm (4).
(1) Remove and discard cotter pin (5).
(2) Remove nut (6), washer (7), bolt (8), washer
(9) (if installed) bushing (10), spacer (11),
washer (12) (if installed), and resistor (3).
(3) Slide bolt (8) back through washer (9), bush-
ing (10), arm (4), LVDT (13), spacer (11),
washer (12), washer (7), and nut (6).
e. Remove resistor (3) from bracket (14).
(1) Remove and discard cotter pin (15).
(2) Remove nut (16), washer (17), bolt (18),
washer (19) (if installed), resistor (3), washer
(20) (if installed), spacer (21), and LVDT (13).
(3) Slide bolt (18) back through washer (19),
washer (20), spacer (21), bracket (14), LVDT
(13), washer (17), and nut (16).
f. Remove rod end bearing (22) from resistor (3).
(1) Remove lockwire from nut (23) and keywash-
er (24).
(2) Hold rod end (22). Loosen nut (23).
(3) Remove rod end (22), nut (23), and key-
washer (24) from resistor (3).
11.205.4. Cleaning
a. Wipe removed and attaching parts with a
clean rag.
11.205.5. Inspection
a. Check for cracked and broken wires. None al-
lowed.
b. Check removed and attaching parts for
cracks. None allowed.
GO TO NEXT PAGE
M04-3307-4
6
5
9
13
11
10
3
12
8
4
7
1716
14
21
19
18
3
13
20
M04-3307-5
15
M04-3307-6
24
23
22
3
