TM 1-1520-238-23
11-893
11.205. PILOT COLLECTIVE CONTROL VARIABLE RESISTOR REMOVAL/INSTALLATION continued
c. Check removed and attaching parts for dam-
age (para 11.190).
d. Check removed and attaching parts for corro-
sion (para 1.49).
e. Check all installed bushing(s) and/or bear-
ing(s) for wear (para 11.190).
f. Check all removed bushing(s) and/or bear-
ing(s) for wear (para 11.4).
11.205.6. Installation
a. Install rod end bearing (22) on resistor (3).
(1) Install rod end (22), nut (23), and key-washer
(24) on resistor (3).
(2) Adjust rod end (22) to 1 INCH between center
of hole in bearing and keywasher (24).
(3) Tighten nut (23).
b. Install resistor (3) on bracket (14).
(1) Remove nut (16), washer (17), bolt (18),
washer (19) (if installed), washer (20) (if
installed), and spacer (21) from bracket (14).
(2) Aline resistor (3) with bracket (14).
(3) Install bolt (18) through washer (19), resistor
(3), washer (20), spacer (21), bracket (14),
LVDT (13), washer (17), and nut (16).
NOTE
Torque procedures will be performed dur-
ing pilot collective control position linear
variable differential transducer (LDVT)
installation.
GO TO NEXT PAGE
M04-3307-7
1 IN
24
23
22
3
1716
14
21
19
18
3
13
20
M04-3307-9