TM 1-1520-238-23
11-897
11.206.
PILOT COLLECTIVE CONTROL VARIABLE RESISTOR ADJUSTMENT – continued
n. Repeat steps k. through m. while observing
multimeter. Adjust resistor shaft (15) length to
obtain 8.2K to 9.1 K OHMS.
(1) Loosen locknut (13) to free keywasher (14).
(2) Adjust resistor shaft (15) length to obtain
8.2K to 9.1K OHMS.
(3) Tighten locknut (13), being careful not to dis-
turb shaft (15) adjustment.
(4) Verify peak resistance value found in step
n.(2) is maintained 25 OHMS.
(5) Lockwire locknut (13) to keywasher (14). Use
wire (item 222, App F).
o. Attach connector P41 (9) to receptacle E1 (10).
p. Attach connector P42 (11) to receptacle E1
(12).
q. Inspect (QA).
GO TO NEXT PAGE
M04-3315-3
14
13
15
M04-3315-5
10
9
ENGINE NO. 1
ENGINE NO. 2
12
11
