TM 1-1520-238-23
11-1085
11.259.
DIRECTIONAL F.S. 348 PUSH-PULL ROD WITH GUIDES REMOVAL
11.259.3. Removal
CAUTION
To prevent damage to flight control sys-
tem components, do not use force if bind-
ing or roughness occurs while moving
controls with hydraulic power.
a. Install -9 rig pin (1) in directional F.S. 216.25
bellcrank (2) and bracket (3).
(1) Locate bellcrank (2) and bracket (3).
(2) If rig pin hole in bellcrank (2) is not alined with
hole in bracket (3), slowly move controls to
aline holes.
(3) Install -9 rig pin (1) through bracket (3) and
bellcrank (2).
b. Install -9 rig pin (4) in directional F.S. 520 bell-
crank (5) and bracket (6).
(1) Locate bellcrank (5) and bracket (6) on inter-
mediate gearbox (7).
(2) Install -9 rig pin (4) through bracket (6) and
bellcrank (5).
c. Remove external hydraulic power (para 1.72).
d. Remove aft end of F.S. 348 push-pull rod (8)
from bellcrank (5).
(1) Remove and discard cotter pin (9).
(2) Remove nut (10).
(3) Remove bolt (11) and bushing (12).
GO TO NEXT PAGE
M04-1792-10
1
3
2
1
M04-1792-7
6
4
5
7
M04-1792-3
12
5
9
8
11
10