TM 1-1520-238-23
11-1088
11.259.
DIRECTIONAL F.S. 348 PUSH-PULL ROD WITH GUIDES REMOVAL – continued
b. Repair rod (8) by replacing sleeves (26).
(1) Locate sleeves (26) on rod (8).
NOTE
The following dimensions will be used
to locate the sleeves on the push-pull
rod. All dimensions are measured from
the end of the push-pull rod (end which
contains the nonadjustable rod end) to
the sleeve edge: Sleeve 1
42.22
.06 INCHES; Sleeve 2
82.16 .06
INCHES, Sleeve 3 122.16 .06 INCH-
ES
Adhesive will not extend beyond the
outside diameter of the sleeves at all
bonded joints.
(2) Bond sleeves (26) to rod (8). Use adhesive
(item 3, App F).
(3) Allow adhesive to cure 24 HOURS.
NOTE
Sealant will not extend beyond the out-
side diameter of the sleeves.
(4) Seal all sleeve edges (27). Use sealing
compound (item 177, App F).
c. Inspect (QA).
d. Install access fairings T355 and L510; secure
fairings R410 and R475 (para 2.2).
END OF TASK
M04-1792-12
82.16 ±.06 INCHES
42.22 ±.06 IN
122.16 ±.06 INCHES
26
8
M04-1792-14
26
8
M04-1792-13
27
