TM 1-1520-238-23
11-1096
Change 5
11.261.
DIRECTIONAL SERVOCYLINDER SUPPORT AND SUPPORT BRACKET
REMOVAL/INSTALLATION – continued
11.261.6. Installation
NOTE
If support bracket was not removed, go to
step c.
a. Check support bracket (4) and directional ser-
vocylinder support (3) for proper fit.
(1) Position bracket (4) on studs (12).
(2) Position support (3) on four gearbox studs
(14).
(3) Check that the three holes (15) of support (3)
are alined with three holes (16) of bracket (4).
(4) If support (3) and bracket (4) are alined, re-
move support (3) and go to step b.
NOTE
When shimming bracket, do not install
shim more than 0.219 INCH thick.
(5) Position three laminated washers (13) on
studs (12).
(6) If support (3) and bracket (4) are not alined,
peel or add additional laminated washers (13)
to obtain proper fit.
(7) Perform steps (1) thru (6) until proper fit is
obtained.
b. Install bracket (4) on gearbox (8).
(1) Position bracket (4) on gearbox (8).
(2) Install three washers (11) and nuts (10).
GO TO NEXT PAGE
M04-1778-7A
16
15
3
14
13
12
4
M04-1778-8A
10
11
8
4
VIEW ROTATED
