TM 1-1520-238-23
11-1211
11.285.
RIGGING LONGITUDINAL FLIGHT CONTROLS BETWEEN PILOT AND CPG CYCLIC
STICKS – continued
11.285.3. Rigging
a. Remove F.S. 165 rod end (1) from longitudinal
servocylinder input lever (2).
(1) Remove and discard cotter pin (3).
(2) Remove nut (4).
(3) Remove bolt (5) and washer (6).
b. Enter pilot station (para 1.56). Observe all
safety precautions.
c. Slowly move pilot cyclic stick (7) to aline lon-
gitudinal rig pin hole (8) with rig pin hole (9) in
pilot cyclic stick base (10).
d. Install -9 rig pin (11) in rig pin hole (8) in cyclic
stick base (10). Use flight control rigging kit.
e. Install cyclic stick warning cover (12). Use
flight control rigging kit.
f. Install -9 rig pin (13) through rig pin holes (14)
in bracket (15) and rig pin hole (16) in F.S. 97
bellcrank (17). Use flight control rigging kit.
(1) If -9 rig pin (13) cannot be installed, adjust aft
end of F.S. 97 push-pull rod (18) to aline rig
pin holes (14) and (16) (para 11.2).
(2) Install -9 rig pin (13).
GO TO NEXT PAGE
1
M04-3016-8
2
3
4
5
6
M04-3016-1
7
8
9
10
11
12
7
M04-3016-2
13
14
15
16
17
18
