TM 1-1520-238-23
11-1250
Change 5
11.292.
RIGGING UPPER LATERAL FLIGHT CONTROLS – continued
v. Remove alinement tool (18) from lateral link
bolt (22).
w. Remove main rotor rigging plate (14) from left
side of mast base (15).
(1) Unfasten clamps (16) under plate (14).
(2) Remove plate (14) from base (15).
x. Install main rotor rigging plate (14) on right
side of mast base (15).
(1) Position rigging plate (14) on top of right side
of mast base (15). Use flight control rigging
kit.
(2) Fasten clamps (16) under plate (14).
y. Check that BASIC DIM pointer (17) alines with
center of alinement tool (18).
(1) Install alinement tool (18) on lateral link bolt
(19). Use alinement tool (Figure D-474, App
D).
(2) Place rigging fixture (20) next to alinement
tool (18).
(3) If BASIC DIM pointer (17) alines with center
of alinement tool (18) go to step z.
(4) If BASIC DIM pointer (17) does not aline with
center of alinement tool (18) repeat steps q.
thru y.
z. Remove -5 rig pin (12) from lateral F.S. 165
bellcrank (11).
GO TO NEXT PAGE
M04-3025-22
16
14
15
22
18
M04-3025-23
16
14
15
19
18
M04-3025-15
20
18
17
M04-3025-10
12
11
