TM 1-1520-238-23
11-1255
11.293.
RIGGING DIRECTIONAL FLIGHT CONTROLS BETWEEN PILOT AND CPG PEDALS – continued
c. Observe pilot directional SPAD (7).
d. Slowly move pilot directional pedals (8) to
aline rig pin holes in SPAD (7).
e. Install -9 rig pin (9) in SPAD (7). Use flight
control rigging kit.
f. Install -9 rig pin (10) in directional F.S. 110
bellcrank (11). Use flight control rigging kit.
(1) If -9 rig pin (10) can not be installed, adjust
forward end of F.S. 110 push-pull rod (12) to
aline rig pin holes (para 11.2).
(2) Install -9 rig pin (10).
g. Install -9 rig pin (13) in CPG SPAD (14). Use
flight control rigging kit.
(1) If -9 rig pin (13) cannot be installed, adjust aft
end of F.S. 59 push-pull rod (15) to aline rig
pin holes (para 11.2).
(2) Install -9 rig pin (13).
NOTE
Rig pins installed must be a drop-fit con-
dition in holes. (A slight drag of rig pin is
acceptable.)
h. Verify drop fit of -9 rig pins (9), (10), and (13).
GO TO NEXT PAGE
M04-3026-1
9
7
8
M04-3026-2
M04-3026-3
15
10
11
12
M04-3026-4
14
13
