TM 1-1520-238-MTF
2-14
PROCEDURE
TROUBLESHOOTING
REFERENCE
STARTING APU – PILOT (CONT)
a. APU control switch – Set to run
position. Verify APU FAIL C/W
segment illuminates. Complete
priming, initiate start, then to run.
CAUTION
The APU 95% cold start switch should
not be used when the ambient tempera-
ture is above 0 F (–18 C) because this
significantly increases component wear
and may cause premature component
failure.
b. 95% switch – Hold to 95% position
as required.
c. Hydraulic system gages – Verify
3000 PSI indicated after PTO clutch
engagement.
d. Caution/warning panel – Verify PRI
HYD PSI, UTIL HYD PSI, OIL PSI
ACC PUMP and APU FAIL
segments extinguished; SHAFT
DRIVEN COMP and APU ON
segments illuminated.
AFTER STARTING APU
WARNING
To prevent injury to personnel, ensure
pylons are clear prior to performing the
generator system check.
A7
A7, A9
A15
