TM 1-1520-238-23
Change 9
3-131
3.38.
TAIL LANDING GEAR SHOCK STRUT REMOVAL/INSTALLATION – continued
(4) Remove pin (15) from strut (1) while helper
supports shock strut (1). Use driftpin.
(5) Remove strut (1) from lugs (8).
d. Remove strut (1) from lugs (16).
(1) Remove and discard cotter pin (17).
(2) Hold bolt (18). Remove nut (19) and washers
(20). Use box wrench.
(3) Remove bolt (18) and washer (21).
(4) Remove strut (1) from lugs (16).
3.38.4. Cleaning
a. Wipe removed and attaching parts with a clean
rag.
b. Clean grounding bracket clamp bonding area
(para 1.47).
3.38.5. Inspection
NOTE
Slight wetting of strut cylinder and seals
insufficient to form a drop is normal.
a. Check shock strut for leaks. None allowed.
b. Check bolt hole of shock strut for elongation.
(1) Maximum elongation is 0.001 INCH.
c. Check rod end bearings at both ends of shock
strut for play.
(1) Maximum radial and axial play is 0.008 INCH.
d. Check shock strut for cracks. None allowed.
GO TO NEXT PAGE
M04–035–5A
15
1
8
18
21
1
16
20
19
17
M04–035–7
