TM 1-1520-238-23
3-126
Change 7
3.36.
TAIL LANDING GEAR ACTUATING CYLINDER WHEEL LOCK TARGET
REPLACEMENT – continued
c. Adjust gap between lock switch assembly (14)
to target (1). Torque two bolts (15) to 30 INCH-
POUNDS.
(1) Remove lockwire from two bolts (15).
(2) Loosen two bolts (15).
NOTE
To adjust gap on the -503 tail landing
gear assembly go to step (3). To adjust
gap on the -503 tail landing gear assem-
bly go to step (4).
(3) On the -503 assembly, adjust switch tail
bracket (16) up or down to obtain a gap of
0.130 to 0.150 INCH between bottom of
switch (14) and top of target (1).
(4) On the -505 assembly, adjust switch tail
bracket (16) up or down to obtain a gap of
0.105 to 0.125 INCH between bottom of
switch (14) and top of target (1).
(5) Tighten two bolts (15).
(6) Recheck gap between switch (14) and target
(1). If needed, loosen bolts (15) and readjust
gap [steps c.(3) or c.(4)].
(7) Torque two bolts (15) to 30 INCH-POUNDS.
Use torque wrench.
(8) Lockwire two bolts (15) to packing nut (17).
Use wire (item 224, App F).
d. Install tail landing gear actuating cylinder
(para 3.32).
e. Inspect (QA).
f. Remove tripod jack (para 1.69).
END OF TASK
M04-2370-4A
15
17
1
14
16
(-505)
(-503)
0.105 TO
0.125 IN
0.130 TO
0.150 IN
