TM 1-1520-238-23
Change 2
3-179
3.49.
TAIL LANDING GEAR WHEEL (WITHOUT GREASE FITTING) AND AXLE
REMOVAL/INSTALLATION – continued
3.49.3. Removal
a. Remove cable assembly (1) from double angle
bracket (2).
(1) Hold nut (3). Remove nut (4).
(2) Remove nut (3) and cable (1) from bracket
(2).
b. Remove wheel (5) from tail landing gear fork
(6).
(1) Remove and discard two cotter pins (7).
(2) Hold two bolts (8). Remove nuts (9), four
washers (10), and structural support (11).
(3) Support wheel (5). Remove bolt (8) and
washer (12) from right-hand side of fork (6).
(4) Remove bolt (8) and bracket (2) from left-
hand side of fork (6).
(5) Remove wheel (5) from fork (6).
c. Remove sleeve spacer (13) from axle (14).
d. Remove axle (14) from wheel (5).
e. Remove adjustable spacer (15) and landing
gear axle lock (16) from axle (14). Use spanner
wrench set.
f. Remove spacer (15) from lock (16).
(1) Remove lockwire from screw (17).
(2) Remove screw (17) and washer (18) from
lock (16) and spacer (15).
(3) Turn spacer (15) counterclockwise to loosen
lock (16).
GO TO NEXT PAGE
2
8
4
3
1
M04-3429-1A
6
11
7
10
9
5
11
109
7
12
8
M04-3429-2
13
5
15
16
14
17
18
