TM 1-1520-238-23
2-274
Change 8
2.77.
MAIN LANDING GEAR RIGHT SHOCK STRUT STRUCTURAL SUPPORT
REMOVAL/INSTALLATION – continued
2.77.6. Installation
NOTE
It may be necessary to add additional
washers to bolts after MWO
1-1520-238-50-46 has been applied.
Use shock strut support wrench set
(figure D-484, App D) to hold nuts as
necessary.
Inspect replacement shock strut sup-
port for guide pins prior to installation.
If support does not have pins installed,
install new pins or reuse pins from old
support.
a. Install support (1) on airframe (2). Torque three
nuts (31), two nuts (28), nut (24), two nuts (21),
nine nuts (14), and nut (11) to 90 INCH-POUNDS.
(1) If required install pins in new support (1) (para
2.77A).
(2) Install bolts (3) and (8) and two bolts (9) on
support (1). Do not tighten.
(3) Install bolt (4), two washers (7), washer (6),
and nut (5) on support (1). Do not tighten.
(4) Install bolts (16) and (17), two washers (19),
and nuts (18) on support (1). Do not tighten.
Use torque wrench adapter.
(5) Install three bolts (30), washers (32), and
nuts (31) on support (1). Torque nuts (31) to
90 INCH-POUNDS. Use torque wrench.
GO TO NEXT PAGE
M04-3745-9
22
21
14
15
27
20
13
13
23
24
25
1
2
13
28
29
28
29
26
M04-3745-5A
7
6
5
12
11
30
3
4
9
8
1
2
16
17
18
19
32
31
