TM 1-1520-238-23
2-598
2.163.
PILOT/CPG CANTED FRAME BEARING REPLACEMENT – continued
2.163.6. Installation
CAUTION
Do not allow sealing compound to en-
ter bearing races or bearing contami-
nation will result.
Installation pressure not to exceed 343
POUNDS or bearing damage will re-
sult.
Staking pressure not to exceed 25,000
POUNDS or bearing damage will re-
sult.
a. Install new bearing (1) in housing (2).
(1) Wear protective gloves when handling bear-
ings. Apply a thin coat of sealing compound
to outer contact surface of bearing (1) and
inner surface of housing (2). Use sealing
compound (item 175, App F) and brush
(item 34, App F).
NOTE
After press-fit installation, the bearing
shall not dislodge from housing when
pressed with finger.
(2) Aline bearing (1) carefully with housing (2).
Press bearing (1) into housing (2) applying
pressure to bearing (1) outer race only
(TM 55-1500-322-24). Bearing (1) shall be
flush to 0.005 INCH below staking surface.
Use puller kit.
(3) Wipe off excess sealing compound.
GO TO NEXT PAGE
M04-3972-3
2
2
1
1
