TM 1-1520-238-23
3-113
3.32.
TAIL LANDING GEAR ACTUATING CYLINDER REMOVAL/INSTALLATION – continued
f. Install hose (1) to nipple (3) in cylinder (2).
(1) Hold nipple (3). Tighten nut (4).
(2) Bleed all air from hydraulic line (para 1.35).
NOTE
If cylinder is being replaced, go to steps
g. thru h. If cylinder is not being replaced,
go to step i.
g. Adjust handle (5).
(1) Remove and discard lockwire from bolt (15).
(2) Loosen self-locking nut (16).
(3) Turn bolt (15) until it bottoms.
(4) Slowly move handle (5) down to a point
where it will not go back up automatically.
(5) Turn bolt (15) out to seat on cylinder (2).
(6) Turn bolt (15) clockwise two turns.
(7) Hold bolt (15). Tighten nut (16).
(8) Lockwire bolt (15) to hole in handle (5). Use
wire (item 224, App F).
h. Adjust proximity switch (para 3.36).
i. Inspect (QA).
j. Perform tail landing gear maintenance opera-
tional check (TM 1-1520-238-T).
k. Remove tripod jack (para 1.69).
END OF TASK
16
15
5
2
5
M04-025-5
3
4
1
FULL DOWN
FULL UP
