TM 1-1520-238-23
4-552
4.164.
NO. 1 OR NO. 2 POWER AVAILABLE SPINDLE CABLE CONNECTING LINKS
REMOVAL/INSTALLATION – continued
4.164.6. Installation
NOTE
Nuts (15) and (20) should be finger tight
only if rigging is to be performed.
a. Install No. 1 rod end (16) on bellcrank (17).
Torque nut (20) 14 to 18 INCH-POUNDS.
(1) Install bolt (19) through bellcrank (17) and rod
end (16).
(2) Install nut (20) on bolt (19).
(3) Hold bolt (19). Torque nut (20) 14 INCH-
POUNDS. Use torque wrench.
(4) Increase torque to aline cotter pin hole, but do
not exceed 18 INCH-POUNDS.
(5) Install new cotter pin (18).
b. Install No. 2 rod end (11) on bellcrank (12).
Torque nut (15) 14 to 18 INCH-POUNDS.
(1) Install bolt (14) through bellcrank (12) and rod
(11).
(2) Install nut (15) on bolt (14).
(3) Hold bolt (14). Torque nut (15) 14 INCH-
POUNDS. Use torque wrench.
(4) Increase torque to aline cotter pin hole, but do
not exceed 18 INCH-POUNDS.
(5) Install new cotter pin (13).
GO TO NEXT PAGE
19
17
20
M04-3929-6
16
18
15
M04-3929-7
14
12
11
13
