TM 1-1520-238-23
4-569
4.167.
PILOT POWER QUADRANT DISASSEMBLY/ASSEMBLY (AVIM) – continued
c. Remove bushing (84) from right power lever
(37) (TM 55-1500-322-24).
(1) Heat area of power lever (37) surrounding
bushing (84). Use heater.
(2) Press bushing (84) out of right power lever
(37). Use arbor press.
d. Install bushing (84) in right power lever (37)
(TM 55-1500-322-24).
(1) Heat area of power lever (37) surrounding
bushing (84). Use heater.
(2) Apply primer to outer edge of bushing (84).
Use primer coating (item 147, App F).
(3) Press bushing (84) in right power lever (37).
Use arbor press.
4.167.7. Installation
a. Install connector J1 (66) on angle bracket (79).
(1) Install four screws (82) through connector
(66) and angle bracket (79).
(2) Install four nuts (81) on screws (82).
(3) Install connector backshell (80) on connector
(66).
b. Install wire harness (73) in connector J1 (66).
(1) Pin identified wires (78) in connector (66)
(TM 55-1500-323-24).
GO TO NEXT PAGE
M04-3926-17
37
84
84
37
81
M04-3926-18
79
82
66
78
80
73
