TM 1-1520-238-23
4-572
4.167.
PILOT POWER QUADRANT DISASSEMBLY/ASSEMBLY (AVIM) – continued
j. Install pilot power quadrant ignition lock
switch (para 4.192).
k. Assemble power lever assembly (1).
NOTE
The following step is typical for left or
right power levers.
(1) Install trigger release (27) on power lever
(40).
(a) Install two screws (46) through bar (45)
into trigger release (27).
(b) Install bar (45) on lever (40).
(c) Install two screws (43) through lower re-
taining plate (44) into lever (40).
(d) Install two screws (41) through upper re-
taining plate (42) into lever (40).
(2) Install quadrant hub (39) in lever shaft (33).
(a) Install hub (39) in lever shaft (33) by turn-
ing counterclockwise.
(b) Using splined end of shaft (5), rotate hub
(39) until recessed 0.25 INCH inside le-
ver shaft (33).
(3) Install friction disk (38), right lever (37), and
friction disk (36) on lever shaft (33).
(4) Install left lever (35) and friction disk (34) on
lever shaft (33).
(5) Install two flat washers (32), tension washer
(31), and support flange (30) on power lever
shaft (33).
GO TO NEXT PAGE
45
M04-3926-24
40
27
46
42
41
44
43
M04-3926-25
30
31
32
36
34
35
37
5
39
33
38
1
