TM 1-1520-238-23
4-564
4.167.
PILOT POWER QUADRANT DISASSEMBLY/ASSEMBLY (AVIM) – continued
(1) Remove support flange (30) tension washer
(31) and two flat washers (32) from power
lever shaft (33).
(2) Remove friction disk (34) and left lever (35)
from lever shaft (33).
(3) Remove friction disk (36), right lever (37), and
friction disk (38) from lever shaft (33).
(4) Remove quadrant hub (39) from lever shaft
(33).
(a) Using splined end of shaft (5), rotate
quadrant hub (39) clockwise.
NOTE
The following step is typical for right or
left power levers.
(5) Remove trigger release (27) from power lever
(40).
(a) Remove two screws (41) and upper re-
taining plate (42) from lever (40).
(b) Remove two screws (43) and lower re-
taining plate (44) from lever (40).
(c) Remove bar (45) from lever (40).
(d) Remove two screws (46) from bar (45)
and trigger release (27).
GO TO NEXT PAGE
M04-3926-8
30
31
32
36
34
35
37
5
39
33
38
M04-3926-9
27
45
46
42
41
44
43
40
