TM 1-1520-238-23
4-717
4.194.
PILOT POWER QUADRANT PANEL – NO. 2 ENGINE INTERLOCK SWITCH
REMOVAL/INSTALLATION (AVIM) – continued
b. Install switch (6) on panel (2).
(1) Install two screws (12) through washers (11),
panel (2), spacer (10), switch (6), and switch
actuator (9).
(2) Apply sealing compound to threads of two
screws (12). Use sealing compound
(item 172, App F).
(3) Install two washers (8) and nuts (7). Do not
tighten.
CAUTION
To prevent damage to switch, ensure
switch actuator does not bend excessive-
ly during switch closure, and that switch
opens past the IDLE position.
c. Adjust switch (6).
NOTE
Switch actuates only when No. 2 engine
throttle lever is between OFF and IDLE.
(1) Set No. 2 engine power lever (23) to IDLE.
(2) Adjust switch (6) so switch actuator (10)
presses plunger (24) to its maximum travel.
(3) Set lever (23) to idle, ensure switch is in open
position.
d. Tighten two nuts (7).
e. Install lacing tape as required. Use tape
(item 202, App F).
GO TO NEXT PAGE
M04-3331-6
7
8
9
10
6
11
12
2
23
THROTTLE LEVERS
IN •IDLE" POSITION
M04-3331-7
M04-3331-8
7
24
6
10
