TM 1-1520-238-23
7-428
7.113.
HYDRAULIC TUBES AND FITTINGS PERMASWAGE REPAIR – continued
7.113.6. Cut Tubing
a. Draw a line parallel to the tube, running
across the section to be cut before cutting the
tube. Use marking pen and a ruler. If the end is to
be replaced, make sure the line is placed in the
same location on replacement section. This line
will be used to aline or “clock” the tube during
assembly.
b. Select appropriate size tube cutter (1). Check
that ratchet handle (2) operates freely and that
cutter wheel (3) and rollers (4) are clean and lubri-
cated.
CHIPLESS CUTTER
Tool
3/16 - 3/8
(-3,-4,-5,-6)
1/2 - 3/4
(-8,-10,-12)
1 - 1-1/2
(-16,-20,-24)
Tubing Cutter
D12530-001
D12531-001
D12532-001
Hex Key
D 9802
D 9802
D 9803
M04-2844-5
1
3
2
4
GO TO NEXT PAGE
M04-2844-4
