TM 1-1520-238-23
Change 1
6-91
6.16.
NO. 7 (APU) DRIVE SHAFT AND ANTI-FLAIL SUPPORT REMOVAL/INSTALLATION – continued
6.16.3. Removal
a. Remove anti-flail support (1) from engine
mount (2).
(1) Remove two nuts (3), washers (4), and
screws (5) attaching support (1) to bracket
(6).
(2) Remove four bolts (7) and washers (8) at-
taching support (1) to mount (2).
(3) Remove shim(s) (9) if installed.
CAUTION
Before removing No. 7 (APU) drive shaft,
ensure that both ends of drive shaft are
adequately supported. Do not allow either
end of drive shaft to drop or hang down
freely. Failure to support drive shaft may
result in damage to drive shaft.
b. Remove No. 7 (APU) drive shaft (10) with sup-
port (1) from deck (11).
(1) Support both ends of shaft (10).
(2) Remove three bolts (12) attaching shaft (10)
to APU output flange (13).
(3) Remove three bolts (14) attaching shaft (10) to
main transmission input flange (15).
(4) Mark drive shaft if it is not to be replaced.
(5) Push shaft (10) forward.
(6) Remove shaft (10) with support (1) from deck
(11).
c. Remove support (1) from shaft (10).
(1) Slide support (1) from end of shaft (10).
GO TO NEXT PAGE
1
M04-0457-2
6
2
5
8
7
4
3
9
14
15
10
1
13
12
M04-0457-3
11
M04-0457-4
1
10
