TM 1-1520-238-23
6-476
6.113.
TRANSMISSION INSTALLATION – CONNECT RIGHT SIDE AREA – continued
a. Install oil filler drain tube (1) on drain fitting
(2).
(1) Slide tube (1) over fitting (2).
(2) Tighten clamp (3).
b. If transmission was replaced, install check
valve (para 6.80).
c. Install right lube oil inlet hose (4) on check
valve (5). Torque nut (6) to 345 INCH-POUNDS.
(1) Install nut (6) on valve (5).
(2) Hold valve (5). Use open end wrench.
(3) Torque nut (6) to 345 INCH-POUNDS. Use
crowfoot and torque wrench.
d. Inspect (QA).
e. Install right lube oil outlet hose (7) on cou-
pling body (8).
(1) Aline sleeve (9) with body (8).
(2) Turn sleeve (9) clockwise until firmly seated
and locking teeth fully engage.
f. If transmission was replaced, install low oil
pressure switch (para 6.78).
g. Install two clamps (10) and (11).
(1) Install screw (12), washer (13), clamps (10),
(11), and nut (14).
h. Install clamp (15) on bracket (16).
(1) Install screw (17) through washer (18), clamp
(15), and bracket (16).
GO TO NEXT PAGE
M04-2972-13
2
3
1
M04-2972-2
5
6
4
12
M04-2972-3
7
9
11
8
13
14
10
M04-2972-4
16
18
17
15
