TM 1-1520-238-23
7-204
Change 8
7.48.
LONGITUDINAL SERVOCYLINDER INSTALLATION continued
p. Install tube clamp (42). Torque screw (43) to 23
INCH-POUNDS.
(1) Position half of clamp (42) under tubes (31)
and (34).
(2) Position other half of clamp (42) over tubes
(31) and (34). Aline mounting holes.
(3) Install screw (43) through washer (44) and
clamp (42).
(4) Torque screw (43) to 23 INCH-POUNDS. Use
torque wrench.
NOTE
If ground cable is installed on helicopter,
go to step q. If not, go to step t.
q. Install cable (45) on servocylinder (3).
(1) f installing a new servocylinder, aline new
clamp (46) on servocylinder (3). If reinstalling
servocylinder, use existing clamp (46).I
(2) Install screw (47) through cable (45), clamp
(46), washer (48), and nut (49).
CAUTION
The lateral servo connector or longitudi-
nal servo connector can be incorrectly
connected to the servocylinder recep-
tacle. Accidentally interchanging con-
nectors between servocylinders can
result in damage to the aircraft.
r. Inspect (QA).
s. Bleed primary and utility hydraulic systems
(para 1.35).
t. Service primary and utility hydraulic systems
(para 1.34).
u. Perform longitudinal (cyclic) flight control rig-
ging maintenance operational check (TM
1-1520-238-T).
GO TO NEXT PAGE
31
42
34
M04-826-9
43
44
45
M04-826-16
49
48
47
3
46
M04-826-8
50
51
