TM 1-1520-238-23
7-208
Change 5
7.49.
LONGITUDINAL SERVOCYLINDER ROD END REPLACEMENT – continued
7.49.3. Removal
WARNING
To prevent movement of bellcrank and
possible injury, support bellcrank be-
fore disconnecting servocylinder. If
injury occurs, seek medical aid.
CAUTION
To prevent damage to rigid hydraulic tube
assemblies, ensure upper end of servo-
cylinder is supported when rod end is dis-
connected from the bellcrank.
a. Remove rod end (1) from bellcrank (2).
(1) Remove sealant from attaching hardware
(para 1.47).
(2) Remove and discard cotter pin (3).
(3) Hold self-retaining bolt (4). Use box wrench.
(4) Remove nut (5). Use socket.
(5) Remove bolt (4) and washer(s) (6), if
installed.
NOTE
Do not remove nylon washer unless it is
loose or excessively worn.
(6) Remove bushing (7) and nylon washer (7.1)
(if necessary).
(7) Remove rod end (1) from bellcrank (2).
b. Measure and record distance A between cen-
ter of rod end bore (8) and top of piston rod
(9).
GO TO NEXT PAGE
4
6
3
M04-823-2A
2
5
1
1
2
M04-823-4A
7
7.1
9
8
M04-823-6
A
