TM 1-1520-238-23
9-32
9.8.
PILOT CIRCUIT BREAKERS (ATTACHED TO BUS BARS) REPLACEMENT – continued
9.8.6. Installation
a. Install new circuit breaker (2).
(1) Insert circuit breaker (2) in panel (4) to seat
tab (20) in locator hole (21).
(2) Install washer (19) and nut (18) on circuit
breaker (2).
b. Install bus bar (16).
(1) Position bus bar (16) and identified wire (12)
on circuit breaker (2).
(2) Install screws (17) through terminal lug (15)
and bus bar (16) into circuit breaker (2).
c. Attach identified wires (12) to circuit breaker
(2).
(1) Install screws (13) through washers (14) and
terminal lugs (15) in circuit breaker (2).
d. Inspect (QA).
e. Install back cover (6) on panel (4).
(1) Position back cover (6) on studs (9).
(2) Install washers (8) and nuts (7) on studs (9).
(3) Install screws (10) and washers (11) as re-
quired.
GO TO NEXT PAGE
M04-1820-6
18
19
4
21
20
2
13
14
15
17
16
12
15
12
4
6
7
9
8
M04-1820-13
11
10
10
11
