TM 1-1520-238-23
9-317
9.86.
CPG INTR LT PANEL RESISTOR R1 OR R2 REPLACEMENT (AVIM)
9.86.1. Description
This task covers:
Removal. Cleaning. Inspection. Installation.
9.86.2. Initial Setup
Tools:
Electrical tool kit (item 378, App H)
Light duty laboratory apron (item 27, App H)
Chemical protective gloves (item 154, App H)
Adjustable air filtering respirator (item 262, App H)
25-watt electric soldering iron (item 332, App H)
Materials/Parts:
Solder (item 189, App F)
Personnel Required:
68X
Armament/Electrical System Repairer
68X3F
Armament/Electrical System Repairer/
Technical Inspector
References:
TM 55-1500-323-24
NOTE
This task is typical for resistor R1 or R2.
9.86.3. Removal
WARNING
Soldering iron can cause severe
burns to personnel and start fires.
Observe all safety precautions when
using soldering iron. If injury occurs,
seek medical aid.
a. Remove resistor (1) from circuit card assem-
bly A1 (2).
(1) Desolder resistor (1) from two terminals (3).
Use soldering iron (TM 55-1500-323-24).
(2) Remove and discard resistor (1).
GO TO NEXT PAGE
M04-5080-1
M04-5080-2
3
3
1
2
