TM 1-1520-238-23
9-333
9.91.
UTILITY MAINTENANCE LIGHT DISASSEMBLY/ASSEMBLY – continued
9.91.6. Assembly
a. Install clamp (8) on base (6).
(1) Position clamp (8) on base (6).
(2) Install two screws (11) through clamp (8),
base (6), washers (10), and nuts (9).
b. Install light (5) on base (6).
(1) Insert light (5) in base (6). Tighten thumb-
screw (7).
WARNING
Soldering iron can cause severe
burns to personnel and start fires.
Observe all safety precautions when
using soldering iron. If injury occurs,
seek medical aid.
c. Install connector (1) on wires (2).
(1) Install backshell (4) loosely on wires (2).
(2) Solder identified wires (2) to connector (1).
Use soldering iron and solder (item 189,
App F) (TM 55-1500-323-24).
(3) Position backshell (4) on connector (1). Install
two screws (3).
d. Inspect (QA).
e. Perform maintenance light maintenance op-
erational check (TM 1-1520-238-T).
END OF TASK
5
4
1
2
3
M04-4525-3
8
11
6
9
10
7
