TM 1-1520-238-23
9-349
9.96.
ANTI-COLLISION LIGHT UNIT REMOVAL/INSTALLATION – continued
d. Remove anti-collision light assembly (5) from
wing tip (2).
(1) Remove four screws (6) and washers (7).
(2) Detach connector P105 (left) or P106 (right)
(8) from receptacle (DS8)J1 (left) or (DS9)J1
(right) (9).
9.96.4. Cleaning
a. Clean removed and attaching parts (para
1.47).
9.96.5. Inspection
a. Check connector for bent pins or damaged
threads (para 9.61).
b. Check removed and attaching parts for dam-
age (para 9.61).
c. Check wires and terminals for wear, cracks,
and cuts (para 9.61).
d. Check removed and attaching parts for corro-
sion (para 1.49).
9.96.6. Installation
a. Install light assembly (5) on wing tip (2).
(1) Attach connector P105 (left) or P106 (right)
(8) to receptacle (DS8)J1 (left) or (DS9)J1
(right) (9).
(2) Position light assembly (5) on wing tip (2).
(3) Install four screws (6) and washers (7).
b. Perform electrical bond check on attaching
parts (TM 55-1500-323-24).
(1) Bond shall be 0.0025 OHM or less. Use
ohmmeter.
GO TO NEXT PAGE
M04-1241-3
8
9
2
5
7
6
7
8
9
5
6
M04-1241-4
2
