TM 1-1520-238-2310-40210.94.PRESSURE FUEL MANIFOLD REMOVAL/INSTALLATION – continuedd. Install fitting (11).(1) Lubricate new gasket (16). Use petrolatum(item 138, App F).(2) Install new gasket (16) on mounting flange(15).(3) Place fitting (11) on gasket (16).(4) Install four bolts (12), washers (14), and nuts(13).(5) Hold bolts (12). Tighten nuts (14).(6) Perform electrical bond check on four bolts(12) (TM 55-1500-323-24).(a) Bond shall be 1.0 OHM or less. Usemultimeter.(7) Seal heads of four bolts (12). Use sealingcompound (item 175, App F).e. Install connector (6).(1) Lubricate two new packings (10). Usepetrolatum (item 138, App F).(2) Install one packing (10) on connector (8) andone packing (10) on nut (7).(3) Install retainer halves (9) between body (8)and nut (7).(4) Lubricate threads of body (8). Use petrolatum(item 138, App F).(5) Slide and hold body (8) over retainer halves(9). Packings (10) should be located on theoutside of retainer halves.(6) Connect nut (7) and body (8) and tighten.GO TO NEXT PAGE12111514 1316M04-352-1210910M04-352-13967878
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business