TM 1-1520-238-23
11-272
11.58.
LATERAL FEEL SPRING CARTRIDGE INSTALLATION – continued
b. Install rod end (8) on bellcrank (9). Torque nut
(10) 30 to 40 INCH-POUNDS.
(1) Install bolt (11) through washers (12) (as re-
quired), bushing (13), bellcrank (9), and rod
end (8) to aline rod end (8) with bellcrank (9).
(a) If rod end (8) alines with bellcrank (9), go
to step b.(11).
(b) If rod end (8) does not aline with bellcrank
(9), go to step b.(2).
(2) Remove lockwire from rod end (8).
(3) Loosen nut (14) until lock (15) is free of shaft
(16).
(4) Adjust rod end (8) to aline bellcrank (9).
(5) Turn rod end (8) clockwise to decrease length
or counterclockwise to increase length.
(6) Hold rod end (8). Tighten nut (14) until lock
engages shaft (16).
(7) Remove cartridge (para 11.57).
(8) Hold rod end (8). Torque nut (14) to 105
INCH-POUNDS. Use torque wrench and
crowfoot.
(9) Install lockwire through nut (14) and lock (15).
Use wire (item 224, App F).
(10) Go to step a.
(11) Check fit of self-retaining bolt (11) (para 11.1).
(12) Install nut (10). Torque nut (10) to 30 INCH-
POUNDS. Use torque wrench.
(13) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(14) Install new cotter pin (17).
GO TO NEXT PAGE
M04-1708-3
9
11
12
13
8
M04-1708-4
8
15
14
16
M04-1708-8
11
17
10
