TM 1-1520-238-23
11-432
11.98.
PILOT CYCLIC LATERAL PUSH-PULL ROD ASSEMBLY REMOVAL/INSTALLATION – continued
11.98.6. Installation
CAUTION
To prevent damage to flight control sys-
tem components, do not use force to
aline bellcrank with bracket or to aline
push-pull rod with bellcrank.
a. Install non-adjustable end of rod (5) on arm
(12). Torque nut (14) 30 to 40 INCH-POUNDS.
(1) Aline rod (5) with arm (12).
(2) Install bolt (15) through washer (16), bushing
(17), arm (12), and rod (5).
(3) Check fit of self-retaining bolt (15) (para
11.1).
(4) Install nut (14). Torque nut (14) to 30 INCH-
POUNDS. Use torque wrench.
(5) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(6) Install new cotter pin (13).
b. Install adjustable end of rod (5) on bellcrank
(6). Torque nut (8) 30 to 40 INCH-POUNDS.
(1) Aline rod (5) with bellcrank (6).
(2) Install bolt (9) through washer (10), bushing
(11), bellcrank (6), and rod (5).
(3) Check fit of self-retaining bolt (9) (para 11.1).
(4) Install nut (8). Torque nut (8) to 30 INCH-
POUNDS. Use torque wrench.
(5) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(6) Install new cotter pin (7).
GO TO NEXT PAGE
16
5
15
12
M04-4376-6
17
13
14
6
9
M04-4376-7
7
8
11
10
5
