TM 1-1520-238-23
11-544
11.124. LONGITUDINAL F.S. 159.62 BELLCRANK REMOVAL/INSTALLATION – continued
b. Install rod (13) on bellcrank (7). Torque nut (15)
30 to 40 INCH-POUNDS.
(1) Aline rod (13) with bellcrank (7).
(2) Install bolt (16) through washer (17), bushing
(18), bellcrank (7), and rod (13).
(3) Check fit of self-retaining bolt (16) (para
11.1).
(4) Install nut (15). Torque nut (15) to 30 INCH-
POUNDS. Use torque wrench.
(5) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(6) Install new cotter pin (14).
c. Install rod (6) on bellcrank (7). Torque nut (9) 30
to 40 INCH-POUNDS.
(1) Aline rod (6) with bellcrank (7).
(2) Install bolt (10) through washer (11), bushing
(12), bellcrank (7), and rod (6).
(3) Check fit of self-retaining bolt (10) (para
11.1).
(4) Install nut (9). Torque nut (9) to 30 INCH-
POUNDS. Use torque wrench.
(5) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(6) Install new cotter pin (8).
d. Inspect (QA).
GO TO NEXT PAGE
13
15
14
M04-4357-9
7
18
17
16
8
6
10
11
12
7
9
M04-4357-10
