TM 1-1520-238-23
Change 2
11-727
11.165. DIRECTIONAL F.S. 156.07 BELLCRANK REMOVAL/INSTALLATION continued
11.165.5. Inspection
a. Check removed and attaching parts for
cracks. None allowed.
b. Check removed and attaching parts for dam-
age (para 11.5).
c. Check removed and attaching parts for corro-
sion (para 1.49).
d. Check all installed bushing(s) and/or bear-
ing(s) for wear (para 11.5).
e. Check all removed bushing(s) and/or bear-
ing(s) for wear (para 11.4).
11.165.6. Installation
a. Install bellcrank (3) on support (14). Torque nut
(16) 30 to 40 INCH-POUNDS.
(1) Install pivot (20) in support (14).
(2) Aline hole (21) with support (14).
(3) Install bolt (18) through washer (19), pivot
(20), support (14), and bellcrank (3).
(4) Install washer (17) and nut (16).
(5) Torque nut (16) to 30 INCH-POUNDS. Use
torque wrench.
(6) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(7) Install new cotter pin (15).
GO TO NEXT PAGE
3
14
19
18
15
16
17
M04-3391-4
18
19
20
14
21
20
