TM 1-1520-238-23
11-747
11.169. DIRECTIONAL F.S. 164.33 PUSH-PULL ROD REMOVAL/INSTALLATION continued
11.169.6. Installation
a. Install non-adjustable end of rod (1) on aft
bellcrank (6). Torque nut (8) 30 to 40 INCH-
POUNDS.
(1) Aline rod (1) with bellcrank (6).
(2) Install bolt (9) through washer (10), bellcrank
(6), and rod (1).
(3) Install bushing (11) in bellcrank (6).
(4) Check fit of self-retaining bolt (9) (para 11.1).
(5) Install nut (8). Torque nut (8) to 30 INCH-
POUNDS. Use torque wrench.
(6) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(7) Install new cotter pin (7).
b. Install adjustable end of rod (1) on aft bell-
crank (2). Torque nut (4) 30 to 40 INCH-
POUNDS.
(1) Aline rod (1) with bellcrank (2).
(2) Install bolt (5) through, bellcrank (2), and rod
(1).
(3) Check fit of self-retaining bolt (5) (para 11.1).
(4) Install nut (4). Torque nut (4) to 30 INCH-
POUNDS. Use torque wrench.
(5) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(6) Install new cotter pin (3).
GO TO NEXT PAGE
8
11
7
6
10
9
1
M04-1794-4
1
3
4
2
M04-1794-5
5