RIGGING PILOT AND CPG LONGITUDINAL CYCLIC STICK STOP BOLTS continued

RIGGING PILOT AND CPG LONGITUDINAL CYCLIC STICK STOP BOLTS continued - TM-1-1520-238-23-7-2_403

RIGGING PILOT AND CPG LONGITUDINAL CYCLIC STICK STOP BOLTS continued - TM-1-1520-238-23-7-2_405

TM-1-1520-238-23-7-2 Helicopter Attack AH-64A Apache (NSN 1520-01-106-9519) (EIC: RHA) Manual
Page Navigation
377

TM 1-1520-238-23 11-1221 11.287. RIGGING PILOT AND CPG LONGITUDINAL CYCLIC STICK STOP BOLTS – continued m. Adjust pilot cyclic stick (1) forward limit stop bolt (11) to contact housing (15). (1) Slowly adjust stop bolt (11) counterclockwise until it contacts housing (15). (2) Hold stop bolt (11). Tighten jam nut (13). (3) Lockwire stop bolt (11) to jam nut (13) and jam nut (16). Use wire (item 224, App F). n. Adjust CPG cyclic stick forward stop bolt (11) to contact 0.020 INCH thickness gage (17) held between CPG cyclic housing (15) and for- ward stop bolt (11). (1) Hold pilot cyclic stick (1) against forward stop bolt (11). (2) Hold 0.020 INCH thickness gage (17) against CPG cyclic housing (15). (3) Slowly adjust forward stop bolt (11) counter- clockwise until it contacts gage (17) against housing (15). (4) Hold stop bolt (11). Tighten jam nut (13). (5) Lockwire stop bolt (11) to jam nut (13) and jam nut (18). Use wire (item 224, App F). o. Observe longitudinal servocylinder piston (14) travel. p. Fully extend piston (14) by slowly pulling aft on pilot cyclic stick (1). (1) Slowly pull aft on stick (1) until piston (14) is fully extended. (2) Hold stick (1) in this position. GO TO NEXT PAGE PILOT 11 13 1 M04-3018-6 15 16 CPG M04-3018-7 17 15 11 13 18 14 M04-3018-8

Privacy Statement
Press Release
Contact