TM 1-1520-238-23
11-1222
11.287.
RIGGING PILOT AND CPG LONGITUDINAL CYCLIC STICK STOP BOLTS – continued
q. Measure and record distance between valve
arm (9) and stop bolt (10) on servocylinder (7).
(1) This is measurement C. Use caliper.
(2) If difference between measurement A and
measurement C is more than 0.030 INCH
slowly push cyclic stick (1) forward until differ-
ence between measurement A and measure-
ment C is less than 0.030 INCH.
(3) Hold stick (1) in this position and go to next
step.
r. Adjust pilot cyclic stick aft limit stop bolt (12)
to contact housing (15).
(1) Slowly turn stop bolt (12) counterclockwise
until it contacts housing (15).
(2) Hold stop bolt (12). Tighten jam nut (13).
(3) Lockwire stop bolt (12) to jam nut (13) and
jam nut (16). Use wire (item 224, App F).
s. Adjust CPG cyclic aft limit stop bolt (12) to
contact 0.020 INCH thickness gage (17) held
between CPG cyclic housing (15) and aft stop
bolt (12).
(1) Hold pilot cyclic stick (1) against aft stop bolt
(12).
(2) Hold 0.020 INCH thickness gage (17) against
CPG cyclic housing (15).
(3) Slowly adjust aft stop bolt (12) counterclock-
wise until it contacts gage (17) against hous-
ing (15).
(4) Hold stop bolt (12). Tighten jam nut (13).
(5) Lockwire stop bolt (12) to jam nut (13) and
jam nut (18). Use wire (item 224, App F).
GO TO NEXT PAGE
10
9
C
7
M04-3018-9
PILOT
1
13
12
15
M04-3018-10
16
CPG
M04-3018-11
13
17
12
15
18
CPG
M04-3018-12
13
12
18
