TM 1-1520-238-23
11-1219
11.287.
RIGGING PILOT AND CPG LONGITUDINAL CYCLIC STICK STOP BOLTS – continued
11.287.3. Rigging
a. Enter pilot station (para 1.56). Observe all
safety precautions.
b. Slowly move pilot cyclic stick (1) to aline lon-
gitudinal rig pin holes (2) and (3) in cyclic
stick base (4).
c. Install -9 rig pin (5). Use flight control rigging kit.
NOTE
Rig pins installed must be a drop-fit con-
dition in holes. (A slight drag of rig pin is
acceptable.)
d. Verify drop fit of -9 rig pin (5).
e. Check that lower lever (6) on longitudinal ser-
vocylinder (7) is alined with upper edge of
boss (8) on servocylinder (7).
(1) If lower lever (6) does not aline with upper
edge of boss (8), rig longitudinal flight con-
trols between pilot cyclic stick and longitudi-
nal servocylinder (para 11.286).
(2) If lower lever (6) is alined with upper edge of
boss (8), go to next step.
f. Measure distance between valve arm (9) and
stop bolt (10) on servocylinder (7).
(1) This is measurement A. Use caliper.
g. Remove -9 rig pin (5) from base (4).
GO TO NEXT PAGE
1
5
4
M04-3018-13
2
3
8
6
M04-3018-2
7
7
10
9
A
M04-3018-3
5
4
M04-3018-1
