TM 1-1520-238-23
11-1260
Change 1
11.294.
RIGGING DIRECTIONAL FLIGHT CONTROLS BETWEEN PILOT PEDALS AND DIRECTIONAL
SERVOCYLINDER – continued
h. Install -5 rig pin (13) in directional F.S. 215
bellcrank (14). Use flight control rigging kit.
(1) If -5 rig pin (13) cannot be installed, adjust aft
end of F.S. 199 push-pull rod (15) on bell-
crank F.S. 199 (15.1) to aline rig pin holes
(para 11.2).
(2) Install -5 rig pin (13).
i. Install -9 rig pin (16) in directional F.S. 348
bellcrank (17). Use flight control rigging kit.
(1) If -9 rig pin (16) cannot be installed, adjust aft
end of F.S. 275 push-pull rod (18) to aline rig
pin holes (para 11.2).
(2) Install -9 rig pin (16).
j. Install -9 rig pin (19) in directional F.S. 520
bellcrank (20). Use flight control rigging kit.
(1) If -9 rig pin (19) cannot be installed, adjust
forward end of F.S. 348 push-pull rod (21) to
aline rig pin holes (para 11.2).
(2) Install -9 rig pin (19).
GO TO NEXT PAGE
M04-3027-4
14
13
M04-3027-19
15
15.1
M04-3027-5
17
16
18
M04-3027-6A
19
24
20
21
