TM 1-1520-238-23
11-1279
11.297.
SERVOCYLINDER ROD END ADJUSTMENT – continued
11.297.5. Adjust Lateral Servocylinder Rod End
a. Install -9 rig pin (19) in lateral F.S. 165 bell-
crank (20). Use flight control rigging kit.
b. Measure and record distance between top lat-
eral servocylinder housing (21) and bottom of
locknut (22).
(1) This is measurement G. Use caliper.
c. Remove -9 rig pin (19) from lateral F.S. 165
bellcrank (20).
d. Move pilot cyclic stick (14) to aline BASIC DIM
pointer (para 11.292).
e. Measure and record distance between top of
housing (21) and bottom of locknut (22).
(1) This is measurement H. Use caliper.
f. Remove servocylinder rod end (23) from later-
al mixer bellcrank (24) (para 7.44).
g. Loosen lock nut (22).
(1) Remove lockwire.
h. Measure and record distance between top of
piston (25) and center of rod end (23).
(1) This is measurement J. Use caliper.
i. Adjust rod end (23) by turning in or out piston
(25).
(1) If measurement G is larger than measure-
ment H, turn rod end (23) into piston (25).
Shorten measurement J an amount equal to
difference between measurements G and H.
(2) If measurement G is smaller than measure-
ment H, turn rod end (23) out of piston (25).
Lengthen measurement J an amount equal to
difference between measurements G and H.
GO TO NEXT PAGE
19
M04-3030-20
19
20
M04-3030-8
22
21
14
G
22
H
M04-3030-9
21
BASIC DIM
POINTER
M04-3030-10
24
23
22
25
J
