TM 1-1520-238-23
11-1282
11.297.
SERVOCYLINDER ROD END ADJUSTMENT – continued
h. Remove servocylinder rod end (36) from di-
rectional bellcrank (37) (para 7.32).
i. Loosen locknut (30).
(1) Remove lockwire.
j. Measure and record distance between top of
piston (38) and center of rod end (36).
(1) This is measurement M. Use caliper.
k. Adjust rod end (36) by turning in or out of
piston (38).
(1) If measurement K is larger than measure-
ment L, turn rod end (36) into piston (38).
Shorten measurement M an amount equal to
difference between measurements K and L.
(2) If measurement K is smaller than measure-
ment L, turn rod end (36) out of piston (38).
Lengthen measurement M an amount equal
to difference between measurements K and
L.
l. Install servocylinder rod end (36) on direction-
al bellcrank (37) (para 7.33).
m. Torque nut (30) to 77 FOOT-POUNDS.
(1) Hold piston rod (38). Use crowfoot.
(2) Torque nut (30) to 77 FOOT-POUNDS. Use
torque wrench.
(3) Lockwire nut (30) to lock (39). Use wire
(item 225, App F).
n. Inspect (QA).
o. Continue rigging directional upper flight con-
trols (para 11.296).
END OF TASK
36
38
30
36
37
M
M04-3030-13
30
M04-3030-21
37
38
39
36
