TM 1-1520-238-23
12-107
12.34.
PILOT ENGINE FIRE PULL SWITCH REMOVAL/INSTALLATION - continued
12.34.6. Installation
NOTE
If replacing switch, go to paragraph
12.34.3 to remove handle from new
switch.
a. Enter CPG station (para 1.56). Observe all
safety precautions.
WARNING
Soldering gun can cause severe
burns to personnel and start fires.
Observe all safety precautions
when using soldering gun. If injury
occurs, seek medical aid.
Do not place heater near flammable
material or allow heater to contact
skin: severe burns can result. Wear
protective equipment. If injury
occurs, seek medical aid.
b. Solder wires (6) to switch (2).
(1) Install sleeving (7) on wires (6). Use
insulation sleeving (item 105, App F).
(2) Solder identified wires (6) to terminals (8).
Use soldering gun and solder (item 189,
App F) (TM 55-1500-323-24).
(3) Position sleeving (7) on terminals (8) and
shrink. Use heater.
c. Attach two identified wires (9) to wires (10).
(1) Install
two
new
splices
(11)
(TM 55-1500-323-24).
GO TO NEXT PAGE
6
2
M04-984-6
10
9
11
8
7
